Oh no! Where's the JavaScript?
Your Web browser does not have JavaScript enabled or does not support JavaScript. Please enable JavaScript on your Web browser to properly view this Web site, or upgrade to a Web browser that does support JavaScript.

GLSCC Viper Chassis Club Car Parts List

Last updated on 14 days ago
The Saw
CLUB CAR PARTS LIST



1. ***GCC Viper brass chassis ***
2. 15x8 CB Design front wheels // or any other type your choice
3. Quick Slicks CB33Z front tires // or any other type your choice
4. ***15x11 CB Design or other manufactured aluminum rear wheels ***rule change 5/21/24
5. ***Quick Slicks CB48 F or XF rear tires ***
6. Slot it 3/32 51mm 0r 54 mm axles // or any other type 3/32 axle
7. ***Slot it 9 tooth pinion ***
8. ***Slot it 28 tooth crown gear (Yellow) ***
9. Front and rear brass or bronze axle bushings (any brand) NO bearings
10. Motor screws
11. Guide flag, braids and nut (weighted type nut allowed)
12. ***Predator motor short can 25K PRD130-25 ***
13. ***Any 1:32 scale hardbody model kit or slot car body that fits will be allowed.

Axle bushings may be installed loose, soldered or glued.
Leaving front bushings loose allows changing wheelbase for different bodies.
Motor installed with screws only. No solder or glue.
Body to be attached with Velcro or pin tube mount. 6/8/24
Must have an interior with driver, plastic or vacuum formed.
Lead wires may be soldered to guide flag clips & motor.
Any weight or lead added must be on the topside of the chassis.
Tires may be trued or coated but may not affect ride height.
Tires may not protrude from any wheel opening more than 3/32”.
No hollow axles.
Entire bottom of chassis must clear .063 on a tech block.

*** 6- Items marked with asterisk must be used no substitutions ​***
_______________________________________________________________________________________


This set up could be used for multiple classes by just changing bodies.
Many 1/32 scale model kits are available to make different classes.
Pony cars, Muscle cars, Nascar, GT or DTM etc. and will accommodate many Carrera and Scalextric bodies as well as many others.

Refer all questions and inquires to George.(Racer X)
Ken
George, did you get a message from me? It doesn't look like it was sent.
Ken
My other questions aside. Will this ever be run as a points series? If so, you should either make the rear tires open or CB48XF only as the firms are no longer available.
The Saw
Rule #13 body rule added 5/17/24.
The Finger
I've had "Staff Wright" 15 x 11 rears on mine. Why can't I keep them?
Ken
Shhh, keep your head down, I don't think anybody will care.
The Saw
Note rule change 5/21/24.
The Saw
Pin tube mount rule added 6/8/24.
Ken
"Tires may not protrude from any wheel opening more than 3/32”

How will this be measured? When looking down from above, from the widest point of the body?
The Saw
You’ll have to ask George, it’s his series.
You can view all discussion threads in this forum.
You can start a new discussion thread in this forum.
You cannot reply in this discussion thread.
You cannot start on a poll in this forum.
You cannot upload attachments in this forum.
You cannot download attachments in this forum.
Moderator: Administrator