Oh no! Where's the JavaScript?
Your Web browser does not have JavaScript enabled or does not support JavaScript. Please enable JavaScript on your Web browser to properly view this Web site, or upgrade to a Web browser that does support JavaScript.

2016 Group C Rules

Last updated on 28 days ago
The Saw
Group C rules
Wheels must remain Stock
Manufacturers with plastic wheels may use equivalent (same diameter, or smaller. same width, or narrower) slot.it or CB Design wheels with appropriate inserts. If correct inserts are not available from manufacturers, they must be made from stock plastic wheels
Axles must remain stock
PPR tires designed for the stock wheel must be used
Front tires must remain stock
True tires and wheels
May coat the front tires
Oil and grease as needed
Remove front and rear axle slop (no chassis mods)
Add lead
Change lead wires
Any braid
Replace guide flag
Glue in motor
Glue in bushings
Create chassis rock, minimal sanding, no chassis mods to sides or post
You may glue or tape in motor pod to fix or limit travel
May use motor of choice up to 25k rpm
Any motor configuration
Motor pod and chassis must be of same manufacturer and without modification to accept motor1/9/17
May use gears of choice, no commercial gears
Axles of non slot.it cars may be replaced with solid slot.it axle

If you have any questions please contact Mike or Rich
You can view all discussion threads in this forum.
You can start a new discussion thread in this forum.
You cannot reply in this discussion thread.
You cannot start on a poll in this forum.
You cannot upload attachments in this forum.
You cannot download attachments in this forum.